Nogmaals ,hem inleren waar zijn 1-6 en neutraal zit.De rode draad aansluiten op de plus.De stekker steek in de diagnose stekker zit achter onder kont.Die van de motor
https://www.healtech-electronics.com/docs/GPAT_UsersGuide_en.pdf
To access the menu, follow these steps, in this order:
- The TOP side of the housing is the touch sensitive area so it must be kept free, away
from all objects. If the unit is in a mount, remove it first.
- Have the gearbox in Neutral.
- Have the ignition OFF (the display must be blank).
- Turn the ignition ON (the display should count up and then show “0”). If the display
does not light up, switch the engine stop switch to RUN position.
- With your index finger (without gloves) tap the top side of the unit and hold your
finger until the first menu sign shows up. Remove your finger now.
Note: If the gearbox is switched to a gear then accessing the menu will be disabled even
if you shift back to neutral. Cycle the ignition key to start over.
5.2. Learning the gear positions
If the unit does not indicate the gears correctly, start the Auto-Learning procedure.
Perform the steps either in the garage with the engine running (put the bike on a rear
stand) or while riding normally.
In the menu, select the “L” sign and do a long tap.
1. When you see the “1” sign flashing, select 1st gear.
The “1” sign starts flashing faster, indicating that the learning is in progress.
2. When you see the “n” (next) sign, select the next gear. The gear number starts
flashing faster when the unit is learning the new gear position.
Repeat this step until all gears have been taught.
Note: If you’d like to cancel or start over the process, turn the ignition key off.
3. If all 6 gears have been learned, “U” (Update) is blinking on the display for a few
seconds. If your bike has 5 gears only, do a long tap. The unit saved the new gear
positions to Flash memory and the unit goes back to normal operation.
Note: if the learning procedure can not be completed,
