GPDS Gear indicator aansluiten

zr7veke

Rookie
16 okt 2011
15
0
Ik heb een Z1000bj 2006
nu wil ik daar een gear indicator op aan sluiten van het merk Gipro
een DS type

naar het schijnt kan dit via 1 kabel
plug en play systeem

maar waar vind ik die fiche op mijn Z1000 en hoe zit deze eruit

heeft iemand hier ervaring mee op zijn Z1000

op youtube vind ik een instalatiefilmpje maar dit is voor bj 07 & 08
en die fiche lijkt ik niet terug te vinden op mijn moto :?
 
Fiche? Is dat een ander woord voor kabel ofzo :?

Net als dat "stilo" een ander woord is voor pen?

anyhoo:

Installation
Find the BLACK, 4-pole male diagnostic connector (KDS), usually near the ECU
box. ( under the seat )

Normally it has a “dummy” female plug (without wires) attached to it.
Note: You may find TWO of this connector on your bike. In this case, try both
connectors, but only one of them will supply data to the GIpro. It will not harm
your bike if you connect the GIpro to the wrong plug first.

Remove the dummy female plug, and connect the GIpro plug.

Route the cable to the mounting location.

Peel off the green plastic from the back of the unit, and mount the display.

Secure the cable with the cable ties supplied.

Setup
This unit comes pre-programmed for Kawasaki bikes. It is fully functional after
installation.
 
Laatst bewerkt:
Geen probleem!

Succes!

Laat je wel even weten als het gelukt is, en hoe je het precies gedaan hebt?
Wel zo fijn voor andere mensen die hetzelfde probleem hebben! :)


mijn moto is occasie gekocht en er zit geen dummy female stekker op
daarmee dat ik deze vraag stelde
ik hoop maar dat het die zwarte "platte" stekker is die nog vrij is

mvg
 
Terug
Bovenaan Onderaan